wrapped around the motor shaft.
*/
-main_body_width_measured = 28.0;
-main_body_length_measured = 31.0;
-main_body_height_measured = 1.5;
-
-arm_width_measured = 3.6;
-arm_length_measured = 79.0;
-arm_height_measured = main_body_height_measured;
-
-cube([main_body_width_measured,
- main_body_length_measured,
- main_body_height_measured],
- center = true);
-rotate(45){
- cube([arm_width_measured,
- arm_length_measured,
- arm_height_measured],
- center = true);}
-rotate(-45){
- cube([arm_width_measured,
- arm_length_measured,
- arm_height_measured],
- center = true);}
+$fn = 300;
+
+// propeller diameter was measured with calipers
+propeller_radius = 46.35 / 2;
+// 7mm from spec
+motor_grippable_height = 8;
+motor_gripper_height = motor_grippable_height / 2;
+holder_height = motor_grippable_height * 1.1;
+
+propeller_radius_measured = 46.35 / 2;
+holder_wall_thickness = 1.2;
+propeller_guard_wall_thickness = 1.2;
+
+motor_diameter = 7;
+motor_height_measured = 17;
+motor_radius = motor_diameter / 2;
+
+module propeller_protector(motor_radius,
+ holder_wall_thickness,
+ propeller_guard_wall_thickness,
+ motor_gripper_height,
+ holder_height,
+ propeller_radius) {
+ propeller_guard_inner_radius = propeller_radius + 1.5;
+ holder_outer_radius = motor_radius + holder_wall_thickness;
+ number_of_arms = 3;
+ linear_extrude(height = motor_gripper_height) {
+ // part that holds the motor
+ difference() {
+ circle(r = holder_outer_radius);
+ circle(r = motor_radius); }
+ for(arm_number = [0: (number_of_arms - 1)]) {
+ rotate(arm_number * (360 / number_of_arms)) {
+ translate([-propeller_guard_inner_radius,
+ -holder_wall_thickness / 2]) {
+ square([propeller_guard_inner_radius - motor_radius,
+ holder_wall_thickness]); } } } }
+ // prop protector
+ linear_extrude(height = holder_height) {
+ difference() {
+ circle(propeller_guard_inner_radius +
+ propeller_guard_wall_thickness);
+ circle(propeller_guard_inner_radius); } } }
+
+propeller_protector(motor_radius,
+ holder_wall_thickness,
+ propeller_guard_wall_thickness,
+ motor_gripper_height,
+ holder_height,
+ propeller_radius_measured);
/*
This file is part of 3d-printables.