challenge-bot.com Git - challenge-bot/blob - README.md

   1 # challenge-bot
   2
   3 ## quickstart
   4
   5 [openSCAD tutorial](http://xib.me/s2ry)
   6
   7 [assemble the hardware](http://xib.me/s378)
   8
   9 [wire and load code to the robot](http://xib.me/s379)
  10
  11 ## Introduction
  12
  13 Most introductory robots are "dead-end" robots that
  14 tend to strand people after they have the first
  15 few robot behaviors are implemented -- obstacle avoid,
  16 wall follow, line follow, don't fall off table, etc.
  17
  18 One of the primary goals of the challenge-bot is to try
  19 to make it expandable from simple to more complex in
  20 reasonable incremental steps.
  21
  22 The base is organized around 1-inch x 1-inch grid peg-board
  23 which is readily available from locations such as Home
  24 Depot, Lowes, and lumber stores.