X-Git-Url: http://challenge-bot.com/repos/?p=challenge-bot;a=blobdiff_plain;f=3d-printables%2Fdeck-holder-data.scad;h=cc1eba21bf97d7872d5e2f98cbdd3a182b567c08;hp=3ac45f62b1ff14ecf4bc1287b894122d0e8c464b;hb=ba794a9f015a6fa4f2a88685dc9412ae81b4513a;hpb=2b986bf7a1e4ca47ce9ed1b9d429ce8e2dd8f86d

diff --git a/3d-printables/deck-holder-data.scad b/3d-printables/deck-holder-data.scad
index 3ac45f6..cc1eba2 100644
--- a/3d-printables/deck-holder-data.scad
+++ b/3d-printables/deck-holder-data.scad
@@ -39,25 +39,6 @@ buffer = 3;
 sonar_holder_length = buffer + between_sonar_centers + sonar_diameter + buffer;
 sonar_holder_width = buffer + sonar_diameter + buffer;
 
-// 3/16 inch in mm deck_depth = 4.7625;
-// 1/4 inch in mm = 6.35
-// subtract a little to be a squeeze fit
-deck_depth = 4.7625 - 0.4;
-// sonar sensor measurements taken with calipers:
-//  10.82 in between, 42.33 outside, 15.82 diameter
-// measured diameter of 15.82 with calipers,
-//  but when printed ends up being too small, so add some
-sonar_diameter = 15.82 + 0.4;
-sonar_radius = sonar_diameter / 2;
-sonar_height = 13.8;
-between_sonar_centers = sonar_diameter + 10.82;
-// the sonar cylinders are placed on the pcb at slightly different positions
-//  from one sensor to the next, so this allows for that variance.
-between_sonar_centers_variance = 2;
-// keep at least this much plastic surrounding the sonar cylinder on all sides
-buffer = 3;
-sonar_holder_length = buffer + between_sonar_centers + sonar_diameter + buffer;
-sonar_holder_width = buffer + sonar_diameter + buffer;
 // sonar_holder_depth is deck_depth minus a little bit to make arm fit
 //  into deck holder
 sonar_holder_depth = deck_depth - 0.7875;