df8e764d |
1 | /* GNU AGPLv3 (or later at your option) |
2 | see bottom for more license info */ |
3 | |
4 | /* protective housing for crazyflie 2.0. |
5 | |
6 | reinforce the arms so they do not snap. |
7 | |
8 | keep the props up high so they do not get hairs from the ground |
9 | wrapped around the motor shaft. |
10 | */ |
11 | |
12 | across_body_screws_outside_measured = 33.3; |
13 | across_body_screws_inside_measured = 32.0; |
14 | |
15 | inside_ = 28.0; |
16 | |
17 | main_body_width_measured = 28.0; |
18 | main_body_length_measured = 31.0; |
df8e764d |
19 | main_body_height_measured = 1.5; |
20 | |
21 | |
e9c572e7 |
22 | arm_width_measured = 3.6; |
23 | arm_length_measured = 79.0; |
24 | arm_height_measured = main_body_height_measured; |
df8e764d |
25 | |
26 | cube([main_body_width_measured, |
27 | main_body_length_measured, |
28 | main_body_height_measured]); |
29 | |
e9c572e7 |
30 | cube([arm_width_measured, |
31 | arm_length_measured, |
32 | arm_height_measured]); |
df8e764d |
33 | |
34 | /* |
35 | This file is part of 3d-printables. |
36 | |
37 | 3d-printables is free software: you can redistribute it and/or modify |
38 | it under the terms of the GNU Affero General Public License as published by |
39 | the Free Software Foundation, either version 3 of the License, or |
40 | (at your option) any later version. |
41 | |
42 | 3d-printables is distributed in the hope that it will be useful, |
43 | but WITHOUT ANY WARRANTY; without even the implied warranty of |
44 | MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
45 | GNU Affero General Public License for more details. |
46 | |
47 | You should have received a copy of the GNU Affero General Public License |
48 | along with challenge-bot. If not, see <http://www.gnu.org/licenses/>. |
49 | */ |