| 1 | // from schematic http://goo.gl/96RKol |
| 2 | collar_radius = 9.2 / 2 + 0.25; |
| 3 | nubbin_radius = 4.48 / 2; |
| 4 | screw_radius = 2.9 / 2 + 0.35; // a little bigger so screws fit through |
| 5 | |
| 6 | motor_height = 22.23; |
| 7 | |
| 8 | // http://freespace.virgin.net/matt.waite/resource/handy/screwsize.htm |
| 9 | _6_radius = 3.5 / 2 + 0.25; |
| 10 | |
| 11 | // measurements we made up: |
| 12 | mount_total_x = 38; |
| 13 | mount_total_y = mount_total_x; |
| 14 | mount_total_z = 3.175; // 3/16 in mm |
| 15 | |
| 16 | module motor_holes() { |
| 17 | collar_x_offset = 10.8; |
| 18 | nubbin_x_offset = 22.23; |
| 19 | // actual motor screw holes are 0.2 further than spec says |
| 20 | screw_x_offset = 30.81 + 0.2; |
| 21 | screw_y_offset = 17.44 / 2; |
| 22 | |
| 23 | translate([collar_x_offset, 0, 0]) { |
| 24 | cylinder(r = collar_radius, h = mount_total_z + 0.1); } |
| 25 | translate([nubbin_x_offset, 0, 0]) { |
| 26 | cylinder(r = nubbin_radius, h = mount_total_z + 0.1); } |
| 27 | translate([screw_x_offset, 0, 0]) { |
| 28 | translate([0, screw_y_offset, 0]) { |
| 29 | cylinder(r = screw_radius, h = mount_total_z + 0.1); } |
| 30 | translate([0, -screw_y_offset, 0]) { |
| 31 | cylinder(r = screw_radius, h = mount_total_z + 0.1); } } } |
| 32 | |
| 33 | module bracket_holes() { |
| 34 | translate([6.2, 0, 0]) |
| 35 | cylinder(r = _6_radius, h = mount_total_z + 0.1); |
| 36 | translate([mount_total_x - 6.2, 0, 0]) |
| 37 | cylinder(r = _6_radius, h = mount_total_z + 0.1); } |
| 38 | |
| 39 | module motor_mount() { |
| 40 | difference() { |
| 41 | cube([mount_total_x, mount_total_y, mount_total_z]); |
| 42 | translate([0, 6.2, -0.05]) { |
| 43 | bracket_holes(); } |
| 44 | translate([1, mount_total_y - motor_height / 2 - 3, -0.05]) { |
| 45 | motor_holes(); } } } |