+ :title [inserting drill bit]
+ (p (figure :legend "arduino to deck / insert bit"
+ (image :file "arduino-to-deck/1-insert-bit.png"))
+ [insert the drill bit into the teeth of the drill.
+ insert it far enough that the teeth will clamp on the
+ smooth part of the bit when they are tightened.])
+ (p (figure
+ :legend "arduino to deck / twist tighten drill teeth"
+ (image :file "arduino-to-deck/2-twist-tighten-drill-teeth.png"))
+ [while holding the drill bit, twist end of the drill to tighten
+ the teeth.
+ make sure that the teeth end up gripping the flat part of
+ the drill bit.])
+ (p [check
+ ,(itemize
+ (item
+ [where should the teeth clamp down on the drill bit?])
+ (item
+ [what would happen if the teeth tightened on the recessed
+ part of the drill bit?]))]))
+ (subsubsection
+ :title [holding drill]
+ (p [hold the drill with one hand on the handle and trigger.
+ put the other hand on the orange nozzle, before the
+ black spinning part.]))
+ (subsubsection
+ :title [arduino placement]
+ (p [the arduino should be placed as shown in this picture.]
+ (figure :legend "arduino to deck / place arduino"
+ (image :file "arduino-to-deck/3-place-arduino.png")))
+ (p [here's a closeup]
+ (figure :legend "arduino to deck / place arduino closeup"
+ (image :file
+ "arduino-to-deck/4-place-arduino-closeup.png"))
+ [the picture above shows where to place the arduino on the deck.
+ the arduino should line up with the holes on the deck.
+ this alignment line is highlighted in pink.
+ on the arduino, there's a hole on the top left, between the
+ orange reset button and black headers.
+ the green circle shows where the hole is.
+ the blue box encloses the arduino hole and two deck holes.
+ place the arduino hole mid-way between the two
+ deck holes.])
+ (p [check
+ ,(itemize
+ (item
+ [should the arduino be upside-down?])
+ (item
+ [what should the upper side of the arduino align with?])
+ (item
+ [why not place the arduino up along the left side of the
+ robot?]))]))