$fn = 60;
// from schematic http://goo.gl/96RKol
-collar_radius = 9.2 / 2;
+collar_radius = 9.2 / 2 + 0.25;
nubbin_radius = 4.48 / 2;
-screw_radius = 2.9 / 2 + 0.1; // a little bigger so screws fit through
+screw_radius = 2.9 / 2 + 0.35; // a little bigger so screws fit through
motor_height = 22.23;
// http://freespace.virgin.net/matt.waite/resource/handy/screwsize.htm
-_6_radius = 3.5 / 2;
+_6_radius = 3.5 / 2 + 0.25;
// measurements we made up:
mount_total_x = 38;
cylinder(r = screw_radius, h = mount_total_z + 0.1);}}}
module bracket_holes(){
- translate([6 + _6_radius, 0, 0])
+ translate([6.2, 0, 0])
cylinder(r = _6_radius, h = mount_total_z + 0.1);
- translate([mount_total_x - 6 - _6_radius, 0, 0])
+ translate([mount_total_x - 6.2, 0, 0])
cylinder(r = _6_radius, h = mount_total_z + 0.1);}
module motor_mount(){
cube([mount_total_x, mount_total_y, mount_total_z]);
translate([0, 6.2, -0.05]){
bracket_holes();}
- translate([0, mount_total_y - motor_height / 2 - 3, -0.05]){
+ translate([1, mount_total_y - motor_height / 2 - 3, -0.05]){
motor_holes();}}}
motor_mount();