+/*
+ Copyright (C) 2015 Daniel Watson
+ See the end of the file for license conditions.
+*/
// challenge-bot
// GNU AGPLv3 (or later at your option)
-// project available at these locations:
-// https://gitorious.org/ozzloy/challenge-bot
-// https://github.com/waynegramlich/challenge-bot
+// project available here:
+// https://challenge-bot.com/
-$fn = 20;
+include <wire-jig-data.scad>
-wire_channel_width = 6;
-wire_channel_height = 6;
-
-wire_diameter_measured = 1.17;
-wire_diameter_fudge = 0.5;
-wire_diameter = wire_diameter_measured + wire_diameter_fudge;
-wire_radius = wire_diameter / 2;
-
-wire_lengths = [10, //strip wire this much
- 35, //short breadboard wire
- 63, //ground to ground
- 120, //arduino breadboard wire
- 180 //motor wire
- ];
-
-module wire_channel_groove_2d(width, height, wire_radius) {
- difference() {
- square([width, height]);
- translate([width / 2, height]) {
- circle(r = wire_radius); } } }
-
-
-module wire_channel_groove(width, height, wire_radius, length){
- rotate(a = 90, v = [1, 0, 0]){
- linear_extrude(height = length){
- wire_channel_groove_2d(width, height, wire_radius); } } }
-
-for(ii = [0:len(wire_lengths) - 1]) {
- translate([wire_channel_width * ii, 0, 0]) {
+for (ii = [0:len(wire_lengths) - 1]) {
+ translate([ wire_channel_width * ii, 0, 0]) {
wire_channel_groove(wire_channel_width,
- wire_channel_height,
- wire_radius,
- wire_lengths[ii]); } }
+ wire_channel_height,
+ wire_radius,
+ wire_lengths[ii]); } }
+
+/*
+ This file is part of challenge-bot.
+
+ Challenge-bot is free software: you can redistribute it and/or modify
+ it under the terms of the GNU Affero General Public License as published by
+ the Free Software Foundation, either version 3 of the License, or
+ (at your option) any later version.
+
+ GNU Affero Emacs is distributed in the hope that it will be useful,
+ but WITHOUT ANY WARRANTY; without even the implied warranty of
+ MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ GNU Affero General Public License for more details.
+
+ You should have received a copy of the GNU Affero General Public License
+ along with challenge-bot. If not, see <http://www.gnu.org/licenses/>.
+*/