[challenge-bot] / README.md

# challenge-bot

## quickstart

[openSCAD tutorial](http://xib.me/s2ry)

[assemble the hardware](http://xib.me/s378)

[wire and load code to the robot](http://xib.me/s379)

## Introduction

Most introductory robots are "dead-end" robots that
tend to strand people after they have the first
few robot behaviors are implemented -- obstacle avoid,
wall follow, line follow, don't fall off table, etc.

One of the primary goals of the challenge-bot is to try
to make it expandable from simple to more complex in
reasonable incremental steps.

The base is organized around 1-inch x 1-inch grid peg-board
which is readily available from locations such as Home
Depot, Lowes, and lumber stores.
Commit	Line	Data
	1	# challenge-bot
	2
	3	## quickstart
	4
	5	[openSCAD tutorial](http://xib.me/s2ry)
	6
	7	[assemble the hardware](http://xib.me/s378)
	8
	9	[wire and load code to the robot](http://xib.me/s379)
	10
	11	## Introduction
	12
	13	Most introductory robots are "dead-end" robots that
	14	tend to strand people after they have the first
	15	few robot behaviors are implemented -- obstacle avoid,
	16	wall follow, line follow, don't fall off table, etc.
	17
	18	One of the primary goals of the challenge-bot is to try
	19	to make it expandable from simple to more complex in
	20	reasonable incremental steps.
	21
	22	The base is organized around 1-inch x 1-inch grid peg-board
	23	which is readily available from locations such as Home
	24	Depot, Lowes, and lumber stores.