define wiring in separate file

[challenge-bot] / 3d-printables / wire-jig.scad

diff --git a/3d-printables/wire-jig.scad b/3d-printables/wire-jig.scad
index dabde952366e44901e8218d84c4b82ee273131bf..4b9bd73f76d6db71fbd3fbe7074fa5c6263b788b 100644 (file)
--- a/3d-printables/wire-jig.scad
+++ b/3d-printables/wire-jig.scad
@@ -1,41 +1,34 @@
+/*
+  Copyright (C) 2015 Daniel Watson
+  See the end of the file for license conditions.
+*/
 // challenge-bot
 // GNU AGPLv3 (or later at your option)
-// project available at these locations:
-// https://gitorious.org/ozzloy/challenge-bot
-// https://github.com/waynegramlich/challenge-bot
+// project available here:
+// https://challenge-bot.com/
 
-$fn = 20;
+include <wire-jig-data.scad>
 
-wire_channel_width = 6;
-wire_channel_height = 6;
-
-wire_diameter_measured = 1.17;
-wire_diameter_fudge = 0.5;
-wire_diameter = wire_diameter_measured + wire_diameter_fudge;
-wire_radius = wire_diameter / 2;
-
-wire_lengths = [10, //strip wire this much
-                35, //short breadboard wire
-                63, //ground to ground
-                120, //arduino breadboard wire
-                180 //motor wire
-               ];
-
-module wire_channel_groove_2d(width, height, wire_radius) {
-  difference() {
-    square([width, height]);
-    translate([width / 2, height]) {
-      circle(r = wire_radius); } } }
-
-
-module wire_channel_groove(width, height, wire_radius, length){
-  rotate(a = 90, v = [1, 0, 0]){
-    linear_extrude(height = length){
-      wire_channel_groove_2d(width, height, wire_radius); } } }
-
-for(ii = [0:len(wire_lengths) - 1]) {
-  translate([wire_channel_width * ii, 0, 0]) {
+for (ii = [0:len(wire_lengths) - 1]) {
+  translate([ wire_channel_width * ii, 0, 0]) {
     wire_channel_groove(wire_channel_width,
-                        wire_channel_height,
-                        wire_radius,
-                        wire_lengths[ii]); } }
+      wire_channel_height,
+      wire_radius,
+      wire_lengths[ii]); } }
+
+/*
+  This file is part of challenge-bot.
+
+  Challenge-bot is free software: you can redistribute it and/or modify
+  it under the terms of the GNU Affero General Public License as published by
+  the Free Software Foundation, either version 3 of the License, or
+  (at your option) any later version.
+
+  GNU Affero Emacs is distributed in the hope that it will be useful,
+  but WITHOUT ANY WARRANTY; without even the implied warranty of
+  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+  GNU Affero General Public License for more details.
+
+  You should have received a copy of the GNU Affero General Public License
+  along with challenge-bot.  If not, see <http://www.gnu.org/licenses/>.
+*/