separate data into *-data.scad for 3d models

[challenge-bot] / 3d-printables / wire-jig.scad

diff --git a/3d-printables/wire-jig.scad b/3d-printables/wire-jig.scad
index dabde952366e44901e8218d84c4b82ee273131bf..59f8434fd1372441a6e387b43c0c77b43d9f1a65 100644 (file)
--- a/3d-printables/wire-jig.scad
+++ b/3d-printables/wire-jig.scad
@@ -4,38 +4,11 @@
 // https://gitorious.org/ozzloy/challenge-bot
 // https://github.com/waynegramlich/challenge-bot
 
-$fn = 20;
+include <wire-jig-data.scad>
 
-wire_channel_width = 6;
-wire_channel_height = 6;
-
-wire_diameter_measured = 1.17;
-wire_diameter_fudge = 0.5;
-wire_diameter = wire_diameter_measured + wire_diameter_fudge;
-wire_radius = wire_diameter / 2;
-
-wire_lengths = [10, //strip wire this much
-                35, //short breadboard wire
-                63, //ground to ground
-                120, //arduino breadboard wire
-                180 //motor wire
-               ];
-
-module wire_channel_groove_2d(width, height, wire_radius) {
-  difference() {
-    square([width, height]);
-    translate([width / 2, height]) {
-      circle(r = wire_radius); } } }
-
-
-module wire_channel_groove(width, height, wire_radius, length){
-  rotate(a = 90, v = [1, 0, 0]){
-    linear_extrude(height = length){
-      wire_channel_groove_2d(width, height, wire_radius); } } }
-
-for(ii = [0:len(wire_lengths) - 1]) {
-  translate([wire_channel_width * ii, 0, 0]) {
+for (ii = [0:len(wire_lengths) - 1]) {
+  translate([ wire_channel_width * ii, 0, 0]) {
     wire_channel_groove(wire_channel_width,
-                        wire_channel_height,
-                        wire_radius,
-                        wire_lengths[ii]); } }
+      wire_channel_height,
+      wire_radius,
+      wire_lengths[ii]); } }