clarify arduino larger drill bit question

[challenge-bot] / guide / challenge-bot-questions.org

diff --git a/guide/challenge-bot-questions.org b/guide/challenge-bot-questions.org
index 515494306d97ac198f37dccd110cfac24a4b6aa9..5eac71f7e3fd9c9c4b2d9f0e1990348aa6abc857 100644 (file)
--- a/guide/challenge-bot-questions.org
+++ b/guide/challenge-bot-questions.org
@@ -6,7 +6,7 @@
     through.
     we drilled through the arduino into the deck.
     1. what would happen if you used a larger drill bit than the one
-      you used for drilling holes for the arduino?
+      you used when drilling holes through the arduino?
     2. why did we use a drill bit that was wider than the body of the
        bolt used to hold the arduino?
     3. why do people use drill bits that are smaller or the same size as
@@ -77,10 +77,14 @@
        without the on/off switch?
     4. what would happen if there were no caster on the back
        of the robot?
-*** misc
+*** tools
     1. do you have a ratcheting socket wrench?
        what is a ratcheting socket wrench?
-    2. what is the robot tread made out of?
-    3. why is it difficult to push the sonar into the sonar holder?
-    4. what would happen if the sonar were easy to push into the sonar
+    2. what is the socket wrench used on?
+    3. what are the pliers?
+    4. what do you use to take the colored part off the end of a wire?
+*** misc
+    1. what is the robot tread made out of?
+    2. why is it difficult to push the sonar into the sonar holder?
+    3. what would happen if the sonar were easy to push into the sonar
        holder?