make crazyflie body

diff --git a/crazyflie-2.0-housing.scad b/crazyflie-2.0-housing.scad
new file mode 100644 (file)
index 0000000..9a38432
--- /dev/null
+++ b/crazyflie-2.0-housing.scad
@@ -0,0 +1,46 @@
+/* GNU AGPLv3 (or later at your option)
+   see bottom for more license info */
+
+/* protective housing for crazyflie 2.0.
+
+   reinforce the arms so they do not snap.
+
+   keep the props up high so they do not get hairs from the ground
+   wrapped around the motor shaft.
+ */
+
+across_body_screws_outside_measured = 33.3;
+across_body_screws_inside_measured = 32.0;
+
+inside_ = 28.0;
+
+main_body_width_measured = 28.0;
+main_body_length_measured = 31.0;
+main_body_diagonal_measured = 79.0;
+main_body_height_measured = 1.5;
+
+
+main_body_arm_width_measured = 3.6;
+
+cube([main_body_width_measured,
+      main_body_length_measured,
+      main_body_height_measured]);
+
+
+
+/*
+  This file is part of 3d-printables.
+
+  3d-printables is free software: you can redistribute it and/or modify
+  it under the terms of the GNU Affero General Public License as published by
+  the Free Software Foundation, either version 3 of the License, or
+  (at your option) any later version.
+
+  3d-printables is distributed in the hope that it will be useful,
+  but WITHOUT ANY WARRANTY; without even the implied warranty of
+  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+  GNU Affero General Public License for more details.
+
+  You should have received a copy of the GNU Affero General Public License
+  along with challenge-bot.  If not, see <http://www.gnu.org/licenses/>.
+*/