start sonar holder that uses binder clip

[challenge-bot] / 3d-printables / sonar-binder-clip-holder-data.scad

/*
  Copyright 2016 Daniel Watson
  See the end of the file for license conditions.
*/
/* challenge-bot
// GNU AGPLv3 (or later at your option)
// project available here:
// https://challenge-bot.com/ */

/*
  this holds an hc-sr04 sonar sensor to a 3/16 inch deck.
  http://fritzing.org/projects/hc-sr04-project
  it can hold the sonar sensor either facing down, or forwards.
  when facing down, it can detect if it passes over the edge of a table.
  when facing forwards, it can detect and follow something in front
  of it.
*/

$fn = 30;

sonar_diameter_measured = 15.82;
sonar_diameter_print_fudge = 0.5;
sonar_diameter = sonar_diameter_measured + sonar_diameter_print_fudge;
sonar_radius = sonar_diameter / 2;

module sonar_binder_clip_holder(sonar_radius) {
	circle(sonar_radius);
}

/*
  This file is part of challenge-bot.

  Challenge-bot is free software: you can redistribute it and/or modify
  it under the terms of the GNU Affero General Public License as published by
  the Free Software Foundation, either version 3 of the License, or
  (at your option) any later version.

  GNU Affero Emacs is distributed in the hope that it will be useful,
  but WITHOUT ANY WARRANTY; without even the implied warranty of
  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
  GNU Affero General Public License for more details.

  You should have received a copy of the GNU Affero General Public License
  along with challenge-bot.  If not, see <http://www.gnu.org/licenses/>.
*/