challenge-bot.com Git - challenge-bot/blob - 3d-printables/Makefile

   1 %.amf: %.scad %-data.scad
   2         openscad-nightly $< -o $@
   3
   4 %-makerfarm.gcode: %.amf makerfarm-i3-v-8in.ini
   5         slic3r \
   6         --load makerfarm-i3-v-8in.ini \
   7         --output $@ \
   8         $<
   9
  10 %-makerfarm.print: %-makerfarm.gcode
  11         cp $< /media/${USER}/3D-PRINTER
  12         sync
  13         umount /media/${USER}/3D-PRINTER
  14
  15 caster-standoff-materia-101.gcode: caster-standoff.amf materia-101-caster-standoff.ini
  16         slic3r \
  17         --load materia-101-caster-standoff.ini \
  18         --print-center 70,50 \
  19         --output $@ \
  20         $<
  21
  22 %-materia-101.gcode: %.amf materia-101.ini
  23         slic3r \
  24         --load materia-101.ini \
  25         --print-center 70,50 \
  26         --output $@ \
  27         $<
  28
  29 %-materia-101.print: %-materia-101.gcode
  30         cp $< /media/${USER}/3D-PRINTER
  31         sync
  32         umount /media/${USER}/3D-PRINTER
  33
  34 pretty-angle-bracket:
  35         astyle --options=astyle-options --recursive "*angle-bracket.scad"
  36
  37 clean:
  38         rm -f *.gcode
  39         rm -f *.amf