challenge-bot.com Git - challenge-bot/blob - arduino-sketches/phase0/README.md

   1 ### Phase 1: Arduino + Blinky LED's:
   2
   3 Goals:
   4
   5 * Cut peg board to size using hack saw
   6 * Get Arduino IDE installed on laptop.
   7 * Drill Arduino mounting holes in peg board
   8 * Mount Arduino to peg board using screws
   9 * Mount Mini Breadboard to peg board
  10 * Install LED + resistor on breadboard
  11 * Hook up LED to Arduino
  12 * Download Blinky LED program
  13
  14 Bill of Materials:
  15
  16 * 1  Arduino(tm) board + USB Cable (SainSmart: 20-011-110: ~$14/10)
  17 * 1  Mini BreadBoard (Ebay: ~$3/10)
  18 * 1  Breadboard cables (Ebay: ~$4/10)
  19 * 1  4in x 5in peg board to mount arduino + miniboard
  20 * 4  small squares of double sided tape
  21 * 3  #4-40 Phillips 1/2" flat-head screws
  22 * 6  #4-40 hex nuts
  23 * 3  #4 lock washers
  24 * 2  Red LED's
  25 * 2  Yellow LED's
  26 * 2  Green LED's
  27 * 6  330 Ohm Resistors
  28
  29 Required Tools:
  30
  31 * 1  Safety glasses!!!
  32 * 1  Laptop Windows or MacOS or Linux
  33 * 1  Hack saw (to cut peg board)
  34 * 1  Phillips screw driver
  35 * 1  Drill + Drill Bits
  36 * 1  Pliers