challenge-bot.com Git - ozzloy@gmail.com/3d-printables/blob - crazyflie-2.0-housing.scad

   1 /* GNU AGPLv3 (or later at your option)
   2    see bottom for more license info */
   3
   4 /* protective housing for crazyflie 2.0.
   5
   6    reinforce the arms so they do not snap.
   7
   8    keep the props up high so they do not get hairs from the ground
   9    wrapped around the motor shaft.
  10  */
  11
  12 across_body_screws_outside_measured = 33.3;
  13 across_body_screws_inside_measured = 32.0;
  14
  15 inside_ = 28.0;
  16
  17 main_body_width_measured = 28.0;
  18 main_body_length_measured = 31.0;
  19 main_body_diagonal_measured = 79.0;
  20 main_body_height_measured = 1.5;
  21
  22
  23 main_body_arm_width_measured = 3.6;
  24
  25 cube([main_body_width_measured,
  26       main_body_length_measured,
  27       main_body_height_measured]);
  28
  29
  30
  31 /*
  32   This file is part of 3d-printables.
  33
  34   3d-printables is free software: you can redistribute it and/or modify
  35   it under the terms of the GNU Affero General Public License as published by
  36   the Free Software Foundation, either version 3 of the License, or
  37   (at your option) any later version.
  38
  39   3d-printables is distributed in the hope that it will be useful,
  40   but WITHOUT ANY WARRANTY; without even the implied warranty of
  41   MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
  42   GNU Affero General Public License for more details.
  43
  44   You should have received a copy of the GNU Affero General Public License
  45   along with challenge-bot.  If not, see <http://www.gnu.org/licenses/>.
  46 */